Monthly Archives: November 2011

Installation

Facing brick paneling and stone walls. 1) The angles and openings 2) Installation of lining 3) lining the walls of paneling for the interior decoration of all rooms bath chosen bunk, or, as it is called, cladding boards. Exterior walls and bath wall made of brick, so to secure the wagon they have a crate: wooden sticks stuffed at a distance of 0.6 m from each other, as well as on the top and bottom. Crate mounted dowels Gvozdev, plugging them into the drilled through holes in the wall bars, and where the planned casing vertical position of boards, bricks are laid horizontally, and where the horizontal – vertical. Ceiling frame to perform better of wide boards, and not from small bars because they are tougher and the installation of lining less springy. The walls define the space for the doors and set the two counters to the door frame and a horizontal crosspiece over it.

C using a box of dowels frame fixed between the uprights. At the same side with the loops exhibited by the level in two planes, and the opposite – on the porch of a dense (door leaf after fitting the box is removed from its hinges and removed so as not to damage it during the painting and decorating). Wiring track layout sketch of wires (as low as possible on the outside of the walls), they passed a hose, which is fixed to elements of the sheathing. Any damage and wiring installed in a metal hose not acceptable length of loose ends should be sufficient to connect the lights, switch, and soldering on the terminals the heater. Luminaires are connected in parallel through the switch. Plating surfaces. After finishing installation of furring, begin laying the lining, which makes pre-measurements and cut the required number of boards. Plating starting from the top of the corner boards are fixed with special metal clips, inconspicuous on the wooden surface.

Combating Mold

13. It is desirable to be able to seek advice from Manufacturer representatives chosen funds in the event of you have any questions. Read the information about the manufacturer and its representatives in the cities. 14. Do not use anti-microbial Pollution compounds that you have to prepare by mixing different reagents. Production of such compounds – industrial business, including sophisticated waste process, qualitative equipment and skilled workers. 15.

Do not use bleach to combat mold. To do this, they are insufficient because of their short-term action. Combating Mold and protect against the appearance of protection Mold can be a relatively simple matter only if it is missing before, no design flaws and room selection of quality tools to protect. All activities are kept to a preventive surface treatment – cheap and cheerful. When it comes to destroying mold, even in local areas, there is need for a complex of measures such as: – identifying the causes of mold and its source appearance – the elimination of the causes of mold – the radical elimination of mold – mold protection. In this case it is best to contact the experts (in the USA does not recommend itself to solve the problem of microbiological pollution, if the area of surface area of more than 90 cm2). Identifying the causes of mold growth due to the detection of design flaws premises, identifying sources of microbial pollution, the definition of the scale of destruction and the elaboration of strategy for future phases. As already mentioned, the mold is associated with high humidity (condensation of moisture on the surface of materials, leaks, accumulation of moisture due to poor ventilation, absorption of ground water, etc.), breach of hygiene standards. Eliminating the causes of mold growth depends on their characteristics and associated usually with completion (Restructuring) design space, tighter enforcement of sanitary rules, modifications of domestic nature.

© 2011-2024 RSAWS All Rights Reserved