Installation

Facing brick paneling and stone walls. 1) The angles and openings 2) Installation of lining 3) lining the walls of paneling for the interior decoration of all rooms bath chosen bunk, or, as it is called, cladding boards. Exterior walls and bath wall made of brick, so to secure the wagon they have a crate: wooden sticks stuffed at a distance of 0.6 m from each other, as well as on the top and bottom. Crate mounted dowels Gvozdev, plugging them into the drilled through holes in the wall bars, and where the planned casing vertical position of boards, bricks are laid horizontally, and where the horizontal – vertical. Ceiling frame to perform better of wide boards, and not from small bars because they are tougher and the installation of lining less springy. The walls define the space for the doors and set the two counters to the door frame and a horizontal crosspiece over it.

C using a box of dowels frame fixed between the uprights. At the same side with the loops exhibited by the level in two planes, and the opposite – on the porch of a dense (door leaf after fitting the box is removed from its hinges and removed so as not to damage it during the painting and decorating). Wiring track layout sketch of wires (as low as possible on the outside of the walls), they passed a hose, which is fixed to elements of the sheathing. Any damage and wiring installed in a metal hose not acceptable length of loose ends should be sufficient to connect the lights, switch, and soldering on the terminals the heater. Luminaires are connected in parallel through the switch. Plating surfaces. After finishing installation of furring, begin laying the lining, which makes pre-measurements and cut the required number of boards. Plating starting from the top of the corner boards are fixed with special metal clips, inconspicuous on the wooden surface.

Comments are closed.

© 2011-2020 RSAWS All Rights Reserved